DIBHAPOXY – 450
(COAL TAR EPOXY-an Anticorrosive coating)

INTRODUCTION:

 DIBHAPOXY- 450, COAL-TAR-EPOXY, being two pack system, i.e. Resin and Hardener, mainly developed  for its versatile use as anti-corrosive coating in chemical Zones and  coastal  area. It is  a  combination  of Epoxy Resin, Coal-Tar and Hardener.

Since the hardener is incorporated into the coal -tar,   the coating results in simple two component system & NO PRIMER IS REQUIRED during application. These two components are mixed before  application  in  equal  proportion  by  volume. Therefore,  the process of weighting odd quantities of resin and Hardener is eliminated.

CHARACTERSTICS OF THE COATING :

Ratio   

:

Resin         part     1 part by volume
Hardener    part     1 part by volume
Pot Life of  mix 

:

 30 TO 50 minutes at  35`C temp.
Viscosity of  mix

:

 2000-4000 CP (Very convenient for brush application)
Coverage

:

Mild Steel  5-6 Sqm/kg. With 120-150 Microns 1 coats Concrete   4-5 Sqm/kg .With 140-160 Microns 1 coats.
Coats recommended

:

 Two coats at an interval of 24 hrs.between the coats.
Curing

:

 Gets completely cured at room temp. within  5-7 days
Visual Appearance 

:

 On complete curing…………GLOSSY BLACK
Shelf-life

:

Min 12 mths.stored at cool and dry place in sealed containers

SURFACE PREPARATION :

For better adhesion it is essential to clean the surface on which DIBHAPOXY -450 is to be applied. To remove dust dirt or loose particle by emery paper, wire brush or  power  tools. To  get  optimum  performance surface must be dry, free from oil grease  and sufficiently roughened.

FIELD OF APPLICATION:

  • Flooring & Mortar Lining In Chemical Plants

  • Waterproofing of Concrete by membrane sand witch process.

  • M. S. Beams &  C-channels for Corrosive chemical Industries. 

  • M. S. Grills  & gates for Residence & Hotels at coastal Zones.

  • M.S. Floating drums of goober gas plants Chases and Mudguards of scooters, Cars, Buses & Trucks

 
SPECIAL PRECAUTION:

Mix only required quantity of the material, which can be utilized within stipulated spot life for period  avoid solidification. Wash all tools and tackles with Industrial solvents immediately after application  is completed.

For further more details, if required, please contact manufactures.
Powered by : Needs Information Services Limited